NetBSDだとatactlだけで行ける。
atactl wd0 smart enable atactl wd0 smart status SMART supported, SMART enabled id value thresh crit collect reliability description raw 1 111 6 yes online positive Raw read error rate 51184 3 95 0 yes online positive Spin-up time 0 4 100 20 no online positive Start/stop count 6 5 100 36 yes online positive Reallocated sector count 0 7 72 30 yes online positive Seek error rate 19009190 9 99 0 no online positive Power-on hours count 1332 10 100 97 yes online positive Spin retry count 0 12 100 20 no online positive Device power cycle count 17 183 100 0 no online positive Unknown 0 184 100 99 no online positive Unknown 0 187 100 0 no online positive Unknown 0 188 100 0 no online positive Unknown 30065229863 189 100 0 no online positive High Fly Writes 0 190 55 45 no online positive Airflow Temperature 45 Lifetime max/min 45/0 191 100 0 no online positive G-sense error rate 0 192 100 0 no online positive Power-off retract count 11 193 100 0 no online positive Load cycle count 17 194 45 0 no online positive Temperature 45 Lifetime max/min 0/27 195 18 0 no online positive Hardware ECC Recovered 51184 197 100 0 no online positive Current pending sector 0 198 100 0 no offline positive Offline uncorrectable 0 199 200 0 no online positive Ultra DMA CRC error count 2418 240 100 0 no offline positive Head flying hours 241042154586701 241 100 0 no offline positive Unknown 68861476 242 100 0 no offline positive Unknown 3223795391
うげ、CRC errorとかありまくりで、criticalものが多いけどどうなん? て、もう片方のHDDもそれなりに出ている。
「 What Do You Want?」とか見ると、Rellocated sector count が0なら いいような感じだな。HDDの温度が取れるのか。これで十分じゃん。
詳細レポートを得るには smartmontools。configure&&make一発。これはFreeBSDでもOK。